Linksys Router/wireless-AP Logging problem

mikepg · 04-04-2005, 11:04 PM

I have a Linksys WRT54G and have enabled incoming and outgoing logging. It doesn't seem to do anything though. Where does it keep the log? I just upgraded to the newest firmware too? any ideas?

office politics · 04-05-2005, 10:53 AM

sounds like they're on the router, search through options/config pgs

http://www.neowin.net/forum/lofivers...p/t266249.html

mikepg · 04-05-2005, 04:27 PM

I can't find a place to view them. I've been through every tab and and there is no IP address to forward the Logs to. I donwloaded the log viewer from linksys from this page:

http://linksys.custhelp.com/cgi-bin/...i=&p_topview=1

I have tried resertting the router and still no luck. what is going on? any suggestions?

aspire · 04-05-2005, 05:52 PM

http://(ip address) of your router usualy takes you to a page where logs can be viewed

mikepg · 04-05-2005, 06:07 PM

Quote:

Originally posted by aspire.comptech
http://(ip address) of your router usualy takes you to a page where logs can be viewed

Yeah, I know how to do all of that. I log in, can enable/disable WEP, Port forwarding, etc. There is just no place where the log can be viewed. I upgraded the bios thikng that it might magically appear but no luck. logging is enabled as well. I've tried everything!

office politics · 04-06-2005, 01:35 AM

this is the only type of logging i see for this router

from http://www.kvd1.com/Support/CommonPages/WRT54g1.htm

Setting up MAC Filtering
The Station MAC Filter option is a very good security feature. This option denies all wireless clients except those listed. To implement this feature please follow these instructions:

Before proceeding, please make sure that all the wireless computers are turned off.

1. From the "Setup" page, on the Log tab.

2. When the Â“LogÂ” area loads, make sure that the Â“Access LogÂ” is set to Enable, if it is not, then click on Enable, then click Apply.

3. Click on the View Log button, and a new window, Â“View LogÂ”, will appear. Click on the Clear Log button, then turn on all the wireless PCÂ’s.

4. After the Wireless PCÂ’s have started and are logged onto the WAP11, click on the Refresh button. You should see all your wireless stations under the Â“MessageÂ” column. Leave this window open and proceed step.

Member Login