Modding Help

Adobe · 05-20-2005, 12:57 AM

i just modded my xbox... after i soldered everything i turned my xbox on to see if everything was working... it worked... then i put my modchip in and when i try to boot it it just turns on for a sec then it turns off and it keeps on doing this... if i press and hold the power button (which is suppose to boot from the xbox not the chip) it works perfectly fine... the display on the front when i try booting it from the chip says its disabled i tried everything i could think of... can anyone help me??? im using the Xecuter 3 Modchip

Agnostic · 05-23-2005, 02:43 PM

Does it flash red and green after turning on and off? Most likely it is one of your connections.

CaptainOblivious · 05-23-2005, 08:32 PM

FRAG.......check that the d0 is soldered correctly in the correct hole.....and you have the pinheader aligned on the LPC in the correct position and that all the pins make clear contact with the LPC holes.

Todvader · 05-30-2005, 11:55 PM

im pretty sure it is your d0 point too. Make sure no solder is anywhere else then is should be. If it fragged, you are out of luck though.

05-20-2005, 12:57 AM	#1 (permalink)
Adobe Newb Techie Join Date: May 2005 Posts: 1	Modding Help i just modded my xbox... after i soldered everything i turned my xbox on to see if everything was working... it worked... then i put my modchip in and when i try to boot it it just turns on for a sec then it turns off and it keeps on doing this... if i press and hold the power button (which is suppose to boot from the xbox not the chip) it works perfectly fine... the display on the front when i try booting it from the chip says its disabled i tried everything i could think of... can anyone help me??? im using the Xecuter 3 Modchip

05-23-2005, 08:32 PM	#3 (permalink)
CaptainOblivious Formerly known as H4x3r Join Date: Dec 2004 Posts: 975	FRAG.......check that the d0 is soldered correctly in the correct hole.....and you have the pinheader aligned on the LPC in the correct position and that all the pins make clear contact with the LPC holes. __________________ http://thetimetaker.blogspot.com/

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

05-23-2005, 02:43 PM	#2 (permalink)
Agnostic Newb Techie Join Date: May 2005 Posts: 10	Does it flash red and green after turning on and off? Most likely it is one of your connections.

05-30-2005, 11:55 PM	#4 (permalink)
Todvader Newb Techie Join Date: May 2005 Posts: 12	im pretty sure it is your d0 point too. Make sure no solder is anywhere else then is should be. If it fragged, you are out of luck though.