The Tech Forums Official Crysis [Warhead] GPU Benchmark Thread - Page 51

yzmxer608 · 09-15-2009, 11:00 PM

Was hoping for it to be a little higher, when I get my new gpu hs I'll oc it some and see what I can get then.

Poizen22 · 09-16-2009, 03:35 AM

Quote:

Originally Posted by LionRed

Thought I would give it a go. Vid cards are not overclocked, the 4.2 Ghz CPU oc is on air.
Might OC the vid cards later to see if score can be pushed.

Hmmm I see 300's in my future. And another EVGA board EVGA | Products.

never did i imagine seeing over 100 fps in crysis grats man.

yzmxer608 · 09-16-2009, 08:41 PM

Did this just for fun. Don't think it used the "very high" settings since I have the demo and that isn't supported.

95BlackGA · 09-16-2009, 10:24 PM

Quote:

Originally Posted by yzmxer608

Was hoping for it to be a little higher, when I get my new gpu hs I'll oc it some and see what I can get then.

You get roughly what I do, and you have a more powerful CPU and GPU. I'm fairly sure I got a little bit higher than you though. I'll have to download the demo since I sold all my Crysis games.

yzmxer608 · 09-16-2009, 11:05 PM

I'll try it again tomorrow and see what I get. It is hot without the AC on though, card was in the upper 70's.

95BlackGA · 09-16-2009, 11:07 PM

Quote:

Originally Posted by yzmxer608

I'll try it again tomorrow and see what I get. It is hot without the AC on though, card was in the upper 70's.

That would be a huge factor. My card is never above 60.

yzmxer608 · 09-16-2009, 11:08 PM

I was getting my hopes up to buy a new gpu heatsink too. Found out the sata cables will be in the way since they plug in right above where the gpu is

.

95BlackGA · 09-16-2009, 11:16 PM

Quote:

Originally Posted by yzmxer608

I was getting my hopes up to buy a new gpu heatsink too. Found out the sata cables will be in the way since they plug in right above where the gpu is

.

You could pick up a 90* angle adapter, or completely new 90* sata cable. They're fairly cheap.

yzmxer608 · 09-17-2009, 06:54 PM

I was thinking about that, not sure they will work though. The IDE socket is right where the cable or the end of the 90* head would be.

yzmxer608 · 09-20-2009, 05:47 PM

OC'ed a little. Seems pretty stable, was testing in furmark for a little while. Highest temp was 81*c (highest before was 85*c, ambient is a little lower now). Had the mem clock higher but furmark was getting a few artifacts so I scaled it back some. Overall 2fps better, think it's pretty good for the stock cooler

.

techPowerUp GPU-Z Validation ks2d8

Member Login