#10 Now cut the tubing and then measure out a second piece the same size unless you want different sizes then just make sure you have enough to cover and part of the sleeving that had freys.
#11 Open up the end of the heat shrink and make sure that it will go over the end of the cable or the wire with out having to put stress on it, so that it wont cause any rip or damage.
#12 Feed the tubing over the end and make sure that you tuck any freys into the tubing as well, if you do not it will cause the sleeving to frey more, and mess everything up.
#13 When you feed it the tubing on the cable, get it to the point where you want or makes it look good.
#14 Now take you heat gun or micro torch and do quick passes over the heat shrink so that it starts to shrink in place. DONT stay in one place to long or you will burn the tubing, sleeving, and maybe your cable.
#15 This is what the cable should look like when all done, make sure that you turn the heat gun or micro torch off, so that you dont burn any thing down.
#16 There you go all finished, you are now one cable closer to getting you rig to look AWSOME!!!
Now you can do this to many different types of devices. some take more work then others, like the fan in this picture. But when said and done, you will be the proud owner of a super nice looking rig!
If I missed anything PM me and I will fix it, also if you need any help or have questions about any kind of case modding, I am very good in any kind of lexan or plexiglass!